Automation Authority Telecom & Energy Systems (AAS) supplies fiber optic cold splice connectors, mechanical splice kits, splice trays, IP68 cable joint closures, fiber protection tubes (heat shrink, c...
HOME / OSPF Silent Interface Core Switch - Automation Authority Telecom & Energy Systems
This objective of this article is to provide a comprehensive guide to configuring Open Shortest Path First (OSPF) routing protocols on Cisco Catalyst 1300X series switches using the Command Line
Before OSPF is configured, the switch must have IP routing enabled to allow it to forward traffic like a router. The following section details how OSPF is configured and works on access
To ensure that OSPF routing information cannot be obtained by the devices of a certain network and the local device does not receive routing update information advertised by other devices, you can run the
To prevent OSPFv3 routing information of a switch from being obtained by other switches on a certain network and prevent the switch from receiving routing information from other switches, you can
If you want to make OSPF routing information is not available by devices in other networks, and make the local device does not receive routing update information published in the network, you can use
Use silent-interface to disable the specified interface from receiving and sending OSPFv3 packets. Use undo silent-interface to remove the configuration.
Solved: So let''s say I have just 2x Cat4k or 6k that I would like to enable OSPF between (one acts as Core switch where routing for access switches is done and other will be used for access
Use the silent-interface command to disable an interface or all interfaces from sending OSPF packets. Use the undo silent-interface command to restore the default.
A disabled interface is a passive interface that cannot receive or send any hello packets. To disable a network from receiving and sending OSPF routes, issue the command on the interface connected to